temperature reduction
英 [ˈtemprətʃə(r) rɪˈdʌkʃn]
美 [ˈtemprətʃər rɪˈdʌkʃn]
网络 温度还原
英英释义
noun
双语例句
- Therefore, this thesis not only discussed about temperature reduction by water sprinkling, but also analyzed the control method for humidity inside the mine pit. 7.
所以本文在探讨降温洒水量的同时，也分析了井巷湿度控制的方法。 - Influence of Hydrogen in Gas on Low Temperature Reduction Pulverization of Charge
氢气对高炉炉料低温还原粉化的影响 - This paper expounds the internal connection and regularity among sintering technological conditions, microscopic structures of sinter and degradation during low temperature reduction.
本文阐明了烧结工艺条件、烧结矿微观组织结构与烧结矿低温还原粉化的内在联系和规律。 - A Discussion on Analytical Method of the Characteristics of Temperature Reduction by Air Condition System in Cab
机车司机室空调系统降温特性分析方法探讨 - Ensure the temperature reduction fans on the rear of the ultrasonic cabinet as well as on the both ends of the transducer work properly.
超音波箱体后端降温风扇应正常运转，振动子两端风扇应正常运转。 - Study on the causes of al_2o_3 aggravating low temperature reduction degradation of sinter
Al2O3加剧烧结矿低温还原粉化原因的研究 - Research on the temperature reduction performance of green solar heat reflective coatings
绿色太阳热反射涂料降温性能研究 - But RDI ( low temperature reduction degradation ( index)) of imported pellets and lump ores is higher than that of high basicity sinters.
但进口球团矿和进口块矿的低温还原粉化指数高于高碱度烧结矿； - For the non-isothermal crystallization, the crystallization rate was increased while speeding up the temperature reduction; according to Avrami equation and Ozawa equation, the ratio of Avrami index and Ozawa index was calculated as 1.31-1.49, the activation energy-87.96 kJ/ mol.
在非等温结晶过程中，结晶速率随降温速率的增大而提高，综合利用Avrami方程和Ozawa方程得到Avrami指数与Ozawa指数的比值为1.31～1.49，非等温结晶活化能为-87.96kJ/mol。 - Combined with phase change coating and other functional coating, thermal infrared phase changed& temperature reduction composite stealthy coating was prepared, which reduced the difficulty of individual application the phase change materials to thermal infrared stealthy, and the performance of every coatings were tested.
将相变涂料与其他功能涂层结合，制备出热红外相变&降温复合隐身涂层，降低了单独将相变材料应用于热红外隐身的难度，并对各涂层的性能进行了测试。